Pinnacle Products International PROTEMP BCB-48-BDF User Manual download pdf (Page 3)

Installation

Simply locate fan in safe, desired position on level ground,

and connect to approved power source.

Operation

This fan is equipped with a 2-speed control switch.

TO START FAN:

1. Be sure the Power Switch is in the middle (OFF)

position.

2. Connect to an approved power source.

3. Make sure area is clear from all obstructions.

4. Push Power Switch to the LOW position and allow to

operate for 10 seconds.

5. Once 10 seconds have passed, you may now push the

Power Switch to the HIGH position.

TO TURN OFF FAN:

1 To turn off the fan, simply return Power Switch to the

middle (OFF) position.

NOTE: For longer parts life, after 10 hours of continu-

ous operation, turn fan off for 15 minutes to allow

motor and fan belt to cool.

Maintenance and Storage

1. Inspect your fan before each use. Check all wires and

extension cords, following the procedure outlined on

Page 2 (Safety Information).

2. After use, always be sure fan’s Power Switch is in the

OFF position before unplugging. Use cord wrap (see

page 4) to keep cord off the ground when transporting

fan.

Belt Tightening / Replacement

1. Remove screws from Rear Guard and tilt wheel

(figure 1).

2. Loosen motor nuts, and motor safeguards (located

above and below motor).

3. Remove belt to replace, or adjust motor to tighten belt

(figure 2).

Belt Replacement (Continued)

Pinnacle Products International, Inc. Portable Air Circulator User’s Manual Page 3

NEVER LEAVE A FAN

OPERATING UNATTENDED

Portable

Air Circulator

figure 1

figure 2

Wiring Diagram

1 2 3 4 5 6

Comments to this Manuals

No comments

Pinnacle Products International PROTEMP BCB-48-BDF User Manual Page 3

Comments to this Manuals